Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFast, Reliable Duct Sealing Across Bedford
Duct sealing in Bedford typically runs $450 – $1,200 for a whole-house seal, depending on how many runs need attention and whether we find disconnected or crushed sections in the attic. Most Bedford jobs take a half day to a full day, and we price them in writing before any work starts. Call (361) 326-5060 for a free estimate – we’ll look at your system and tell you exactly what needs sealing and what doesn’t.
We’ve been crawling through Bedford attics since 2004, and the pattern is consistent: homes built from the 1960s through the 1990s with original ductwork that was never properly sealed at the plenum and takeoffs. Our crews dispatch from the Cleveland office and carry mastic, mesh, and the right tools to fix what we find – not just tape over it. Whether you’re off Rockside Road, near the Bedford Reservation, or in one of the ranch neighborhoods between Northfield and Broadway, we’ve likely worked on a house with the same duct configuration as yours.
Why Hollis Air Duct Cleaning Is Bedford’s Preferred Duct Sealing Company
Bedford homeowners call us back because we show up inside the window, price the job in writing, and leave the site clean – that’s The Garrison Standard, and it’s how every Hollis crew operates. We’re not the cheapest bid you’ll find, and we don’t try to be. We’re the bid you can trust because the number on the page is the number at the door.
Our technicians are background-checked and uniformed, and our phones are answered by a live person 24 hours a day, 7 days a week – no voicemail loops, no callback queues. Every duct sealing job in Bedford carries the 365-Day Done Right Promise: if the seal fails or the problem returns within a year, we come back and make it right at no charge, including a free second visit. Roy Castellanos built this operation on written guarantees, not handshakes, and that’s the standard our Bedford crews work to.
We know the local housing stock: the 1970s ranches with flex duct sagging under blown insulation, the 1980s two-stories with takeoffs sealed by the original installer with foil tape that’s now dust, the split-levels near Glenwood Road where a later remodel crushed a return run nobody noticed. That local knowledge means we find problems faster and fix them right the first time.
Duct Repair in Bedford
Duct Repair in Bedford means fixing the physical damage we find in attics and crawl spaces: disconnected boots, crushed flex runs, corroded metal sections, and joints that have worked loose after decades of thermal cycling. Most Bedford homes need repair before sealing can even begin – there’s no point sealing a duct that’s kinked or separated at the collar. A typical duct repair in Bedford runs $200 – $600 per section, with whole-system repairs ranging $800 – $1,800 depending on accessibility and how much original material needs replacement.
Disconnected Boots and Collars
The boot is the fitting where duct meets register, and in Bedford’s older homes these were often secured with a few sheet-metal screws and no sealant. Over forty years of vibration and temperature swing, the connection loosens and attic air leaks straight into your supply. We reconnect with mechanical fasteners, then seal with mastic and mesh for a joint that won’t reopen next summer.
Crushed or Kinked Flex Runs
Flex duct buried under insulation or compressed by a storage board in the attic chokes airflow and creates pressure imbalances that pull debris into the system. We replace damaged sections with properly supported new flex or rigid duct, sized to match the original design airflow. In Bedford’s humid climate, restricted airflow also means colder duct surfaces and more condensation – fixing the crush fixes the moisture problem too.
Air Duct Sealing in Bedford
Air Duct Sealing in Bedford is the finishing work that makes repair last: sealing every joint, seam, and penetration with mastic and fiberglass mesh, not foil tape that dries out in a hot attic. A proper seal stops the conditioned-air loss that’s driving up your electric bill and stops the return-side leaks that pull insulation fibers and dust into your breathing air. Whole-house air duct sealing in Bedford typically costs $450 – $1,200, with smaller partial-system seals starting around $300.
Mastic Sealing at Plenums and Takeoffs
The plenum is the big box on top of your air handler, and the takeoffs are the smaller ducts branching off it. These are the highest-leakage points in most Bedford systems because they were never sealed properly at installation. We brush on water-based mastic – a thick, flexible sealant – and embed fiberglass mesh at stress points. It cures to a rubbery finish that flexes with temperature changes and won’t dry crack like tape.
Cabinet and Coil Sealing
We seal the air handler cabinet itself, including the filter rack and coil access panel. In Bedford’s near-year-round A/C runtime, every gap in the cabinet is a condensation surface where mildew grows. Sealing the cabinet is part of the job, not an extra, because an unsealed cabinet undoes the work we did on the duct.
Trusted Brands We Service in Bedford
Our Bedford crews carry sealing and repair materials from Abatement Technologies and Guardsman, plus professional-grade tools from Rotobrush and Nikro for the cleaning and inspection work that precedes sealing. We stock mastic, mesh, collars, and flex duct in common sizes so we’re not making a supply run in the middle of your job. For filtration upgrades after sealing, we source Honeywell and Aprilaire products – the same brands commercial HVAC contractors use – sized to your system and installed before we leave. Fast turnaround matters because a partially sealed system runs worse than an unsealed one; we don’t start jobs we can’t finish the same visit.
Common Duct Sealing Problems We See in Bedford Homes
- Foil tape failures at plenum joints. The original installer taped the takeoffs and walked away. After twenty Bedford summers in a 140-degree attic, the adhesive is dust and the joint’s leaking 15 – 20 percent of your conditioned air into the insulation. Tape is a temporary fix; mastic is the permanent one.
- Crushed attic runs hidden under blown insulation. A storage board laid across a flex run, or a run kinked during a 1990s insulation upgrade, chokes airflow and creates negative pressure that pulls attic debris straight into your supply registers. We find these with camera inspection, not guesswork.
- Humidity-driven mold at unsealed cabinet gaps. Bedford’s humid subtropical climate means A/C runs ten months a year, and every unsealed gap in the air handler cabinet is a cold surface where condensation breeds mildew. Sealing the cabinet stops the moisture source that cleaning alone can’t fix.
- Return-side leaks pulling insulation fibers. An unsealed return duct in the attic or garage is essentially a vacuum cleaner hose in a dusty space. In central Bedford neighborhoods, this is the source of the gray debris homeowners notice at their registers – and it’s a sealing problem, not a filter problem.
Pricing for Duct Sealing in Bedford, OH
A typical duct sealing job in Bedford runs $450 – $1,200 for a whole-house seal, with partial-system work starting around $300. Duct repair, when needed before sealing, adds $200 – $600 per section. What drives the price: how many runs need attention, whether we find disconnected or crushed sections requiring replacement, and accessibility – a fully finished attic versus an open truss space changes the labor hours significantly.
We do not quote per-vent or offer teaser coupon prices that balloon once we’re inside. We give one flat price per system, agreed in writing before work starts, based on what we find during inspection. Every estimate is free, and we’ll show you camera footage of what we found so you can decide with full information. Call (361) 326-5060 to schedule – estimates take about 45 minutes and there’s no obligation.
We Also Serve Cities Near Bedford
Our crews regularly handle Duct Sealing in Bedford and the surrounding communities, including Maple Heights, Solon, Beachwood, and Independence. If you’re in one of these areas and your home shares the same vintage and duct configuration as Bedford’s 1960s – 1990s stock, the same failure patterns and the same fixes apply. Call us and we’ll route the nearest crew.
Serving Bedford, OH - Our Local Coverage Area
We’re based in the Bedford area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Duct Sealing in Bedford
We show you before-and-after photos from inside your ducts, including the plenum, takeoffs, and any repaired sections – not just the register faces. Our Bedford crews use camera inspection to document the actual condition of hidden runs, and we leave you with a written summary of what was sealed, what was repaired, and what materials were used. If a company won’t show you the inside of the duct, they didn’t do the work. Call (361) 326-5060 and we’ll walk you through exactly what we document on every job.
Bedford’s humid subtropical climate with hot, humid summers and mild winters means your A/C runs nearly year-round, putting constant pressure on duct joints and accelerating tape adhesive failure in hot attics. The high humidity also means every unsealed gap is a condensation surface where mold can grow, making proper sealing more critical here than in drier climates. Most Bedford homes benefit from inspection every 5 – 7 years, sooner if you notice debris at registers or uneven cooling between rooms.
The low quotes are usually tape-only jobs that fail within a season, or “sealing” that only addresses visible register boots while ignoring the plenum and hidden attic runs where the real leakage happens. A proper seal uses mastic and mesh at every joint, includes camera verification, and addresses the air handler cabinet – that’s the $450 – $1,200 range we quote. If someone offers whole-house sealing for under $300, they’re not doing the work. Call (361) 326-5060 for an honest assessment of what your system actually needs.
We answer calls 24 hours a day, 7 days a week with a live person, and we schedule urgent appointments for situations like a completely disconnected return duct or visible mold blowing from registers. True emergencies in duct sealing are rare – most problems develop over months – but when they happen, we prioritize getting a crew out fast. For non-urgent work, we schedule within a few business days and arrive inside the quoted window.
Every duct sealing job in Bedford is covered by our 365-Day Done Right Promise in writing: if the seal fails, the leak returns, or the original problem recurs within one year, we come back and make it right at no charge, including a free second visit. No negotiation, no deductible, no “service call fee” to honor the guarantee. Roy Castellanos put this in writing because a handshake warranty isn’t worth the paper it’s not printed on. Call (361) 326-5060 and we’ll include the guarantee terms in your written estimate.
Written by Roy Castellanos, Owner at Hollis Air Duct Cleaning, serving Bedford and Northeast Ohio since 2004.