Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Fast, Reliable Duct Sealing Across Strongsville
Duct sealing in Strongsville typically runs $450 – $1,200 for a whole-house seal, depending on whether we’re patching a few disconnected joints or reworking long flex-duct runs in a two-story colonial. Most Strongsville jobs take a half day, and we price them in writing before any mastic goes on. If your upstairs bedrooms stay hot while the first floor freezes, or your energy bills keep climbing despite a newer furnace, the problem is often in the ducts, not the equipment. Call us at (361) 326-5060 for a free estimate.
We’ve worked in Strongsville long enough to know the difference between a 1950s ranch near the historic center and a 1990s build off Royalton Road. Our crews dispatch from our Cleveland office and carry the tools to handle both: mastic and mesh for corroded galvanized seams, and new flex runs with proper supports for the kinked sections we find in subdivisions like Waterford Crossing and Deerfield Village. Roy Castellanos, who leads Hollis Air Duct Cleaning, built this operation on The Garrison Standard: show up inside the window, price it before we touch it, and leave the site clean. That’s the standard our Duct Sealing in Strongsville crews are held to on every call.
Why Hollis Air Duct Cleaning Is Strongsville’s Preferred Duct Sealing Company
Strongsville homeowners don’t call us because we’re the cheapest. They call because they’re tired of estimates that balloon once the van is in the driveway. Every Hollis job starts with a written price that does not move at the door. Our Duct Sealing technicians are background-checked, uniformed, and accountable to The Garrison Code: arrive inside the quoted window, explain what you’re paying for, and finish by the book.
We’ve sealed ducts in the ranch homes near Pearl Road and in the sprawling colonials of Deerfield Village. That range matters because the fix for a corroded galvanized trunk is nothing like the fix for a crushed flex run pinched between joists. Our crews carry Rotobrush rotary systems and Nikro negative-air machines so we can inspect before we seal, not guess.
The 365-Day Done Right Promise backs every seal we put on a Strongsville home. If a joint we sealed fails within a year, we come back and make it right at no charge, including a free second visit. No negotiation, no runaround. That’s written on every invoice.
Phones are answered by a live person 24 hours a day, 7 days a week. No voicemail loops, no callback queues, no waiting until Monday to schedule.
HVAC Duct Sealing in Strongsville
HVAC Duct Sealing in Strongsville is the process of closing leaks, gaps, and disconnected joints in your forced-air system so the air you’ve already paid to heat or cool actually reaches the rooms it was meant for. In a typical Strongsville home, we find 20 – 30% of conditioned air escaping into attics, crawl spaces, or wall cavities before it ever hits a register. That waste shows up as uneven temperatures, dust pulled from construction cavities, and utility bills that climb every season.
Strongsville’s climate makes this worse than it looks. Cold winters and humid summers mean your system runs hard year-round. Every gap in the ductwork pulls unconditioned air in and pushes conditioned air out, so your furnace or AC works overtime to compensate. Spring pollen and fall leaf debris get drawn through outdoor intakes, too, and any leak in the return side becomes a delivery system for that debris straight into your living space.
What the Process Looks Like
We start with a pressure test and camera inspection, not a sales pitch. Our tech pressurizes the system and measures how much air escapes, then runs a camera through the trunk lines to find the source. In Strongsville’s 1990s subdivisions, we often find flex duct that has sagged off supports or been crushed against framing. Near the historic center, we see galvanized seams that have corroded through after fifty-plus years of temperature swings.
Materials We Use
We seal with water-based mastic, reinforced with fiberglass mesh on larger gaps. Mastic stays flexible as ducts expand and contract, which matters in Strongsville’s climate. For disconnected collars or failed flex connections, we replace the damaged section and support it properly so it doesn’t fail again. We don’t use duct tape; it dries out and peels within a few years.
Duct Repair in Strongsville
Duct Repair in Strongsville goes beyond sealing when the ductwork itself is damaged, disconnected, or improperly installed from the start. We see this constantly in the Royalton Road-area subdivisions where long flex-duct runs with sharp bends were installed fast during the building boom and have since sagged, kinked, or pulled loose at the boots. A sealed duct that is still crushed or pinched solves nothing; the restriction stays, and your system keeps working harder for less airflow.
Repair costs in Strongsville run $300 – $800 for localized fixes like replacing a crushed flex run or remounting a register boot that was cut too loose into drywall. More extensive rework, like replacing a corroded galvanized trunk line in an older ranch, can reach $1,500 – $2,800. We price it in writing after inspection, not before we know what we’re looking at.
When Repair Beats Replacement
Homeowners in Waterford Crossing and Deerfield Village often call us convinced their furnace is dying. In most cases, the equipment is fine; the ducts are failing to deliver. Reconnecting a few joints, replacing crushed sections, and sealing properly restores balanced airflow without a $6,000 system swap. We show you the camera footage so you can see the difference.
Register Boot and Plenum Work
A common issue in Strongsville’s finished basements: register boots cut sloppily into drywall or plaster, leaving gaps that pull basement air into the supply side. Sealing the duct won’t fix that; the boot needs to be remounted flush and sealed to the wall cavity. We handle that as part of the repair, not as an add-on.
Trusted Brands We Service in Strongsville
We stock parts and materials from Aprilaire, Abatement Technologies, and Guardsman so Strongsville jobs don’t wait on shipping. Our Nikro negative-air machines and Rotobrush rotary systems are the same tools commercial crews use in hospitals and schools, and we bring them into residential jobs because homeowner ductwork deserves the same standard. If your system uses Honeywell or Aprilaire filtration components, we can inspect and seal around those units without disturbing the factory calibration. Fast turnaround matters in Strongsville’s climate; you don’t want gaps open when the first cold snap hits.
Common Duct Sealing Problems We See in Strongsville Homes
- Crushed flex runs in Royalton Road subdivisions. The 1990s building boom here meant long flexible duct spans with minimal support. Over years, gravity and vibration pull them against joists, pinching airflow to entire zones. Sealing a crushed run traps the restriction; we replace and support it first.
- Corroded galvanized seams in pre-1970s ranches. Homes near the historic center often have original metal ductwork that has rusted at the joints. Sealing without cleaning first just traps debris against wet metal. We negative-air clean, then seal with mastic.
- Disconnected collars at the air handler. Vibration from the blower unit works connections loose over time. We find this in two-story colonials with furnaces in the basement; the main trunk separates slightly, dumping conditioned air into the utility room.
- Leaky return boots pulling attic or basement air. In Strongsville’s humid summers, a leaky return in a hot attic draws moisture and mold spores straight into your living space. Sealing the boot and the surrounding cavity fixes the path, not just the duct.
Pricing for Duct Sealing in Strongsville, OH
A typical whole-house duct sealing in Strongsville runs $450 – $1,200. Smaller jobs, like sealing a few accessible joints in a ranch with a full basement, land at the lower end. Complex work in a two-story colonial with long flex-duct runs, multiple disconnected sections, and register boot repairs pushes toward the higher range. We do not price per vent; we price per system, agreed in writing before work starts.
What moves the number: accessibility (crawl space vs. full basement), extent of damage, whether we need to replace sections before sealing, and whether the system needs cleaning first. We always inspect before we quote. Estimates are free, and the price we write down is the price you pay. Call (361) 326-5060 to schedule.
We Also Serve Cities Near Strongsville
Our crews work throughout Cuyahoga and Medina counties, including Strongsville neighbors in Berea, North Royalton, Brunswick, and Olmsted Falls. Same standards, same written pricing, same 365-Day Done Right Promise.
Serving Strongsville, OH - Our Local Coverage Area
We’re based in the Strongsville area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Duct Sealing in Strongsville
Cleaning removes debris; Strongsville Dryer Vent Cleaning and sealing stops the leaks that let debris back in. In Strongsville’s climate, return-side gaps pull humid summer air and pollen into the system, so a clean duct gets dirty again fast if the leaks stay open. We inspect for leaks during every cleaning and recommend sealing when we find them. Call (361) 326-5060 for an exact quote – estimates are free.
It’s usually a duct problem. We were called to a two-story colonial in Waterford Crossing where the upstairs bedrooms ran hot all summer while the first floor stayed cold; a camera inspection showed two crushed flex runs pinched against a joist and a disconnected collar at the air handler. Our tech reconnected the runs, sealed the joints and boots with mastic under negative pressure, and the homeowner’s room-to-room swing dropped noticeably in the same week. The furnace was fine; the ducts were failing to deliver. Call (361) 326-5060 and we’ll show you what the camera sees.
We start with a negative-air cleaning to remove corrosion debris and loose rust, then seal every seam and takeoff with mastic and mesh. Galvanized trunks near Pearl Road and the historic center often have pinhole leaks at the seams and failed connections at each branch. Sealing over dirty metal traps moisture and accelerates corrosion, so cleaning first is non-negotiable. The full process takes a half day and runs $600 – $1,200 depending on system size. Call (361) 326-5060 for an exact quote – estimates are free.
Yes. Strongsville’s humid continental climate means your HVAC runs heavily in both winter and summer; every leak forces the system to work harder and longer. Sealing a typical home restores 20 – 30% of lost airflow, which translates to shorter run times and lower utility bills. Most Strongsville homeowners see the difference in the first billing cycle after we seal. Call (361) 326-5060 for an exact quote – estimates are free.
We pressurize the system and measure total leakage, then run a camera through the trunk lines to locate the failure. In Strongsville’s 1990s subdivisions, disconnected collars at the air handler and crushed flex runs are the most common finds. In older homes near the center, we look for separated seams and failed takeoff connections. We show you the footage before we quote, so you know exactly what we’re fixing and why. Call (361) 326-5060 for an exact quote – estimates are free.
Written by Roy Castellanos, Owner at Hollis Air Duct Cleaning, serving Strongsville since 2004.




Before
After
Before
After
Before
After